Register terminal initial setup
This article applies to Dutchie POS and Greenbits.
Before connecting any peripherals to your Register terminal:
- Tilt the screen fully up and carefully lay the Register terminal on its back. Use a Phillips-head screwdriver to remove the screw beneath the monitor, then remove the cover to access the input hub.
- If you are using the recommended Ethernet connection, route the Ethernet cable through the cable management slot at the bottom of the stand and behind the clip.
- Connect the Ethernet cable to the terminal, but don't connect the power cable yet.
Next steps
Connect peripherals to the Register terminal:
- Receipt printer & cash drawer
- Label printer
- Barcode scanner
- Scale
- If you have a Customer-Facing Display (CFD), connect other peripherals first, then start up and log in to your Register terminal before setting up the CFD.