Register terminal initial setup for Dutchie POS and Greenbits
This article applies to Dutchie POS and Greenbits.
Learn how to get set up with the Register Terminal for Dutchie POS and Greenbits
Things to know
- This article applies to both Dutchie POS and Greenbits.
Before connecting any peripherals to your Register terminal:
- Tilt the screen fully up and carefully lay the Register terminal on its back. Use a Phillips-head screwdriver to remove the screw beneath the monitor, then remove the cover to access the input hub.
- If you are using the recommended Ethernet connection, route the Ethernet cable through the cable management slot at the bottom of the stand and behind the clip.
- Connect the Ethernet cable to the terminal, but don't connect the power cable yet.
Next steps
Connect peripherals to the Register terminal:
- Receipt printer & cash drawer
- Label printer
- Barcode scanner
- Scale
- If you have a Customer-Facing Display (CFD), connect other peripherals first, then start up and log in to your Register terminal before setting up the CFD.