Follow this guide to configure your A&D FX-300i scale for use with Greenbits. Note that this scale is not NTEP-certified. If you need an NTEP-certified scale, use the A&D FX-300iN.

Power on the scale

Connect the scale to a power outlet and wait for the Standby indicator, then press ON-OFF to turn the scale on

 

Configure transmission rate

  1. Press and hold the SAMPLE button to enter the configuration menu. Release the button once the display changes to bASFnc.
  2. Press SAMPLE repeatedly until the display reads SiF.
  3. Press PRINT once. The display will change to bPS, followed by a number.
  4. Press RE-ZERO or TARE repeatedly until the reading is:
  5. Press PRINT to save this setting.
  6. Turn the scale off and then on again.

Configure data parity

  1. Press and hold the SAMPLE button to enter the configuration menu. Release the button once the display changes to bASFnc.
  2. Press SAMPLE repeatedly until the display reads SiF.
  3. Press PRINT once. The display will change to bPS, followed by a number.
  4. Press the SAMPLE button repeatedly until you see btPr.
  5. Press RE-ZERO or TARE repeatedly to select either:
  6. Press PRINT to save this setting.
  7. Turn the scale off and then on again.

Configure the scale to transmit weight readings to the Register app

  1. Press and hold the SAMPLE button to enter the configuration menu. Release the button once the display changes to bASFnc.
  2. Press SAMPLE repeatedly until the display reads dout.
  3. Press PRINT once. The display will change to Prt, followed by a number.
  4. Press RE-ZERO or TARE repeatedly until the display reads Prt 3.
  5. Press PRINT to save this setting.
  6. Turn the scale off and then on again.