Connect a scanner to the Dutchie POS Register
This article applies to Dutchie POS.
Learn how to connect the barcode scanner to the Dutchie Register.
Wired scanner setup
- Set up the scanner stand. Place the scanner with the scan window face down on the stand
- Insert the included USB connector cable into the scanner base until it clicks into place.
- Connect the other end to the register, routing the cable through the cable management slot and clip.
Wireless scanner setup
- Insert the included USB connector cable into the base of the scanner dock until it clicks into place.
- Connect the other end to the register, routing the cable through the cable management slot and clip.
- Insert the battery pack into the base of the scanner and place the scanner in the dock with the battery pack facing down.
Next steps
Configure the barcode scanner or connect other hardware to the Register: